User Manual

38
 Step 8
Use side cutters to trim the pushrod tube as shown.
 Step 9
Make a Z-bend in the 17
3
/
4
-inch (450mm) throttle
pushrod. Make the bend on the end without the threads.
 Step 10
Attach the Z-bend to the carburetor by inserting the
Z-bend in the outer hole of the carburetor arm as shown.
 Step 11
Slide the engine back into position on the mounts. (See
Step 4 for details.) Position the engine so the drive washer
is 4
5
/
8
-inch (118mm) forward of the firewall. Tighten all
four 8-32 x 1-inch machine screws evenly to secure the
position of the engine.
Section 7: 4-Stroke Installation