User Manual
41
Required Parts
• Fuselage assembly • Servo
• Snap link
• Plywood pushrod standoff
Required Tools and Adhesives
• Pencil • Thin CA
• Drill bit: 5/64-inch (2mm) • Pliers
• Side cutters • Pin drill
• Phillips screwdriver • Medium CA
Step 1
Slide the plywood pushrod standoff onto the pushrod
tube. The exact location will be determined later in this
section of the manual.
Step 2
Follow Steps 1 through 4 under Section 5: Radio
Installation to install the throttle servo into the fuselage.
Step 3
Use a felt-tipped pen to mark the pushrod where it crosses
the outer hole on the servo horn.
Step 4
Use a pair of pliers to make a 90-degree bend in the
pushrod at the mark made in the previous step.
Section 8: Throttle Servo Installation