User Manual

42
 Step 5
Use a pin drill and a 5/64-inch (2mm) drill bit to
enlarge the outer hole in the servo arm. Slide the
pushrod wire through the hole in the servo horn. Slide
the snap link onto the pushrod wire, then rotate it until
it snaps onto the wire.
 Step 6
Use side cutters to remove the excess wire. Leave at least
1/16-inch (1.5mm) exposed beyond the connector to
prevent the wire from coming out of the connector.
 Step 7
Slide the plywood pushrod standoff so it can be glued to
the side of the fuselage using medium CA as shown.
Section 8: Throttle Servo Installation