User Manual

4
Optional Field Equipment
• Fieldmate™ Pre-built Flight Box (HAN117) • Cleaner & towels
• Blue Block After Run Oil (EVOX1000) • Power Panel (HAN106)
• 12V 7Ah Sealed Battery (HAN102) • PowerPro™ 12V Starter (HAN161)
Required Tools and Adhesives
Tools
• Adustable wrench • Hobby knife
• Phillips screwdriver (large) • Phillips screwdriver (small)
• Ruler
Adhesives
• Pacer Z-42 Threadlock
Using the Manual
This manual is divided into sections to help make assembly easier to understand, and to provide breaks between each
major section. In addition, check boxes have been placed next to each step to keep track of each step completed. Steps
with a single box (
) are performed once, while steps with two boxes ( ) indicate that the step will require
repeating, such as for a right or left wing panel, two servos, etc. Remember to take your time and follow the directions.
Before Starting Assembly
Before beginning the assembly of the Pulse
™
XT, remove each part from its bag for inspection. Closely inspect the
fuselage, wing panels, rudder, and stabilizer for damage. If you find any damaged or missing parts, contact the place
of purchase.If you find any wrinkles in the covering, use a heat gun or sealing iron to remove them. Use caution while
working around areas where the colors overlap to prevent separating the colors.
HAN100 – Heat Gun
HAN150 – Covering Glove
HAN101 – Sealing Iron
HAN141 – Sealing Iron
Sock