User Manual
8
Required Parts
• Fuselage • Landing gear
• 6-32 x 1/2" socket head screw (3)
• #6 washer (3)
• Wheel pant (right and left)
• 4-40 x 3/8" socket head bolt (4)
Required Tools and Adhesives
• Hex wrench: 3/32", 7/64" • Threadlock
Step 1
Attach the landing gear to the bottom of the fuselage using
three 6-32 x 1/2" socket head bolts and three #6 washers.
Put a little threadlock on the bolts to prevent them from
vibrating loose during flight.
Step 2
Secure the wheel pant to the landing gear using two
4-40 x 3/8" socket head screws. Make sure to use
threadlock to prevent the screws from loosening
during flight.
Step 3
Check that the wheel can spin freely without rubbing on
the wheel pant. If it does, loosen the 4mm nut and 4mm
locknut and reposition the wheel so it can spin freely.
Step 4
Repeat Steps 2 and 3 to install the remaining
wheel pant.
Section 1: Landing Gear Installation