User Manual
9
Required Parts
• Fuselage
• Receiver battery • Receiver
Step 1
Wrap the receiver and receiver battery in 1/4" (6mm)
foam to protect them from engine vibrations.
Step 2
Plug the servos, extensions and switch harness into the
receiver. Plug the receiver battery and switch harness
together. Place the receiver and receiver battery into the
fuselage.
Step 3
Route the receiver antenna to the rear of the fuselage
using the pre-installed antenna tube.
Note: Do not cut the excess antenna wire as
it will reduce the range of your radio system.
Section 2: Receiver and Battery Installation