User Manual

15
Required Parts
• Fuselage assembly • Landing gear
• Wheel pant (left and right) • Axle w/nut (2)
• 5/32-inch wheel collar w/setscrew (4)
• 1/16-inch wheel collar w/setscrew (2)
• Tail wheel, 1-inch (25mm)
• Main wheel, 2
3
/
4
-inch (70mm) (2)
Required Tools and Adhesives
• Threadlock • Adjustable wrench (2)
• Hex wrench: 3/32-inch, 7/64-inch
• Hex wrench: 1.5mm (supplied with kit)
 Step 1
Attach the landing gear to the fuselage using two
6-32 x 1/2-inch socket head screws and two #6 washers.
Note the landing gear is swept towards the rear of the
fuselage as shown in the photo.
Note: Use threadlock on the screws to
prevent them from vibrating loose in flight.
o Step 2
Use two adjustable wrenches to attach the axles to the
landing gear.
o Step 3
Use a file to create a flat on the bottom of the axle. This
will give the setscrews an area to bite into, helping prevent
the loss of the wheel collars in flight.
Section 2: Landing Gear Installation