User Manual

24
Required Parts
• Fuselage assembly • Fuel tank
• 19
3
/
8
-inch throttle pushrod • Cowling
• #4 washer (4) • Spinner assembly
• #8 washer (8) • Throttle servo
• Hook and loop strap • Standard servo arm
• 8-32 nylon lock nuts (4)
• 8-32 x 1 machine screw (4)
• 8-32 x 1
1
/
4
-inch-inch machine screw (4)
• 4-40 x 3/8-inch socket head screw (4)
• Pushrod connector w/setscrew and snap keeper
Required Tools and Adhesives
• Screwdriver: #1 Phillips • Pin drill
• Drill bit: 5/64-inch (2.5mm), 11/64-inch (4.5mm)
• Threadlock
• Hex wrench: 3/32-inch • Propeller
• Rotary tool w/sanding drum • Propeller reamer
 Step 1
Attach the engine mount rails to the firewall using four
8-32 x 1-inch machine screws and four #8 washers.
Note: Use threadlock on the screws to
prevent them from vibrating loose in flight.
 Step 2
Position the engine on the engine mounting rails so
the drive washer is 5
3
/
4
-inch (146mm) forward of the
firewall as shown.
 Step 3
Use a pencil to mark the locations for the four engine
mounting screws onto the engine mounting rails.
Section 4: Glow Engine and Cowling Installation