User Manual
23
Twin Otter ARF Assembly Manual
Step 7
Use a ruler to measure the vertical centerline of the
rewall and mark it with a felt-tipped pen. Measure
down 1 9/32 inch from the top of the rewall and mark
a horizontal line.
Step 8
Use a drill motor and 5/16-inch drill bit to drill a hole
5/32 inch each side of the centerline.
Step 9
Use a round le to remove the material between the
holes, creating a slot measuring 5/16 x 5/8 inches.
Step 10
Place a #6 steel washer onto each of the 6-32 Allen
head machine screws. Insert the screws and washers
in the engine mounts, noting that the modied screw
locates in the lower of the two holes under the beveled
edge of the right-hand mount.
Step 11
Apply a drop of threadlock to each of the screws then
use a 7/64-inch hex wrench to secure the mounts to
the rewall.
Step 12
Perform steps 1 through 7 beginning on page 20 to
install the cowling on the nacelle. Set the front face of
the cowl 3 7/16 inches from the rewall when taping it
in place to drill the mounting holes in the nacelle.