User Manual

10
  Step 8
Prepare an aileron servo by installing the grommets
and brass eyelets provided with the servo. Secure
a 9" (228mm) servo extension to the servo using a
commercially available connector or with string or
unwaxed dental floss.
  Step 9
Tie the string that exits the servo opening to the servo
extension. Use the string to pull the servo lead through
the wing. Use a piece of tape to keep the extension from
falling back into the wing.
  Step 10
Place the servo into the opening with the servo
output towards the leading edge of the wing. Use a
felt-tipped pen to mark the locations for the four servo
mounting screws.
  Step 11
Remove the servo and drill the locations for the servo
mounting screws using a 1/16" (1.5mm) drill bit.
Apply a few drops of thin CA to each hole to harden the
wood, which will help in preventing the screws from
damaging the wood.
Section 1: Aileron Installation