User Manual

11
  Step 12
Secure the servo using the screws provided with the
servo. Remove the stock servo horn and install a long
servo arm in its place. Remove the side of the arm that
does not align with the control horn.
  Step 13
Enlarge the outer hole of the servo arm using a 3/32"
(2.5mm) drill bit. Remove the pushrod keeper from the
linkage and slide the bend to the servo arm. Secure the
pushrod to the servo arm by replacing the pushrod keeper.
  Step 14
Attach the clevis to the control horn. With the radio system
on and the aileron trim and stick centered, check that the
aileron is centered when viewed from the wing tip. Adjust
the length of the linkage if necessary.
  Step 15
Use tape on the servo lead to prevent it from falling back
into the wing.
 Step 16
Repeat Steps 1 through 15 for the remaining aileron servo.
Section 1: Aileron Installation