User Manual
12
Required Parts
• Landing gear w/wheels • Fuselage
• 1" (25mm) tail wheel • Rudder assembly
• Stabilizer assembly • 4-40 locknut (3)
•#4 washer (7) •#8 washer (3)
• 5/64" wheel collar • 4-40 setscrew
• 4-40 x 1/2" socket head screw (4)
• 8-32 x 3/4" machine screw (3)
• Pre-assembled 5
1
/
8
" (134mm) rudder linkage
• Pre-assembled 4
7
/
8
" (124mm) elevator linkage
Required Tools and Adhesives
• Servo w/hardware (2) • Long servo arm (2)
• Adjustable wrench • Threadlock
• 18" (458mm) servo extension
• 24" (610mm) servo extension
Step 1
Attach the landing gear to the bottom of the fuselage using
three 8-32 x 3/4" machine screws and three #8 washers.
Put a little threadlock on the screws to prevent them from
vibrating loose during flight.
Step 2
Attach the wheel pants using four 4-40 x 1/2" socket head
screws and four #4 washers.
Step 3
Slide the threaded rods from the rudder assembly into the
holes in the stabilizer. The two forward rods go through
the stabilizer as shown.
Section 2: Landing Gear and Tail Installation