User Manual

17
 Step 9
Install the throttle servo into the fuselage. Use the opening
closest to the pushrod. Turn on the radio system and
center the throttle stick and trim. Position the servo horn
onto the servo so the horn is perpendicular to the servo
centerline.
 Step 10
Remove the servo horn and attach the pushrod connector
to the throttle servo arm using the connector backplate.
You will need to enlarge the hole in the servo arm using a
5/64" (2mm) drill bit.
 Step 11
Use the radio to move the throttle to the low setting
using the stick and trim. Move the pushrod so the
carburetor is closed. Secure the pushrod wire using a
3mm x 5mm machine screw.
 Step 12
Check that the throttle operates from the radio without
binding at low and high throttle. Use the ATV setting
of the radio or change the position of the clevis at the
carburetor or the pushrod connector at the servo to
eliminate any binding.
Section 3A: Four-Stroke Engine Installation