User Manual

Required Parts

•#8 washer (4)

• Rubber band (2)

• Pushrod connector

• 8-32 locknut (4)

• 8-32 x 1

" screw (4)

• 20" (508mm) throttle pushrod

• 3

" (83mm) spinner w/hardware

• Pushrod connector backplate

• 3mm x 5mm machine screw

Required Tools and Adhesives

• Servo w/hardware • Ruler

• Drill • Phillips screwdriver

• Hobby knife • Rotary tool

• Sanding drum

• Drill bit: 5/64" (2mm), 5/32" (4mm)

Note: Installing the Evolution

26GT will require some minor

modifications to your Twist

™

150.

 Step 1

Remove the hatch from the fuselage. Slide the rubber

band back holding the fuel tank in position and remove

the fuel tank.

Note: You will need to install gas

compatible fuel lines and prepare

the metal fuel tubing as follows.

 Step 2

Remove the stopper from the fuel tank using a Phillips

screwdriver. Remove the fuel lines from the stopper and

set them aside. Prepare the tubing by placing a drop of

solder on the ends of the brass tubing as shown. This

will keep the fuel line from slipping off the tube when

combined with the following steps.

 Step 3

Slide gas compatible fuel lines back onto the brass

tubes. Use fine wire to secure the fuel lines. The wire

is placed behind the solder applied in the previous step

to keep the tubes in place.

Section 3B: Gasoline Engine Installation