User Manual

20
 Step 8
Use a 1" hole saw or rotary tool to make a hole in the
firewall that will be below the fuel tank.
 Step 9
Use plywood to create a shelf inside the fuselage to mount
the ignition and battery for your engine. Make sure the
ignition is secure to the plate, and the plate is secure
inside the fuselage. Route any necessary connections
through the 1" hole made in the firewall in Step 7. Install
a Switch Harness (JRPA004) in the fuselage opposite the
side the radio switch will be mounted to.
Note: Make sure your ingition system
with battery will not interfere with
the fuel tank. Place the battery back
in the fuselage if necessary.
 Step 10
Install the fuel tank back inside the fuselage.
 Step 11
Attach any necessary items to the engine using the
instructions provided with the engine. Mount the engine
to the mount using four 8-32 x 1
1
/
4
" screws, four #8
washers and four 8-32 locknuts.
 Step 12
Slide the 20" (508mm) throttle pushrod into the pushrod
tube and attach the clevis to the carburetor arm.
Section 3B: Gasoline Engine Installation