User Manual

 Step 16

Install the throttle servo into the fuselage. Use the opening

closest to the pushrod. Turn on the radio system and

center the throttle stick and trim. Position the servo horn

onto the servo so the horn is perpendicular to the servo

centerline.

 Step 17

Remove the servo horn and attach the pushrod connector

to the throttle servo arm using the connector backplate.

You will need to enlarge the hole in the servo arm using a

5/64" (2mm) drill bit.

Section 3B: Gasoline Engine Installation

 Step 18

Use the radio to move the throttle to the mid-point

setting using the stick and trim. Move the pushrod so the

carburetor is at mid-point. This installation method will

provide for a more linear throttle response. Secure the

pushrod wire using a 3mm x 5mm machine screw.

 Step 19

Check that the throttle operates from the radio without

binding at low and high throttle. Use the ATV setting

of the radio or change the position of the clevis at the

carburetor or the pushrod connector at the servo to

eliminate any binding.