User Manual

23
Required Parts
• Fuselage • Wing
• 1/4-20 x 1
1
/
2
" nylon bolt (2)
• Canopy
Required Tools and Adhesives
• Canopy glue • Flat screwdriver
• Felt-tipped pen • Masking tape
• 1/4" foam
 Step 1
Place a flat piece of foam into the fuselage, followed by
the shaped radio foam. Plug the servos and extensions
into their proper location in the receiver. Route the receiver
antenna wire through the tube on the right-hand side of
the fuselage to the tail. Place the receiver and receiver
battery into the foam.
 Step 2
Place the remaining flat foam over the receiver and
receiver battery. Slide the radio plate into position
and secure it using a 4-40 X 1/2" socket head screw
and #4 washer.
 Step 3
Remove the covering from the opening on the left side
of the fuselage for the switch harness. Install the harness
using the hardware provided with the harness.
Section 4: Final Assembly