User Manual
8
Required Parts
• Wing panel w/ailerons
• Servo w/hardware (2)
• Servo extension, 9" (228mm) (2)
• Pre-assembled 3
1
/
2
" (89mm) aileron linkage (2)
Required Tools and Adhesives
• Drill • Thin CA
• Drill bit: 1/16" (1.5mm), 3/32" (2.5mm)
• T-pins • Phillips screwdriver
• Long servo arm • Rotary tool
• CA hinge (8)
Step 1
Locate four CA hinges. Place a T-pin in the center of
the hinges.
Step 2
Use a 1/16" (1.5mm) drill bit to drill a hole in the center
of each hinge location in both the wing and aileron. This
creates a tunnel that the CA can pass through allowing the
CA to penetrate further into the hinge.
Note: Using a rotary tool and 1/16" (1.5mm)
drill bit will make the perfect hole as it
removes the excess wood fibers from the hole.
Step 3
Place the hinges in the precut slots in the aileron (or wing
if you prefer). Each T-pin will rest against the edge when
installed correctly.
Section 1: Aileron Installation