User Manual

  Step 4

Slide the aileron and wing together. The gap between the

aileron and wing should be approximately 1/64" (.4mm).

Align the end of the aileron to the wing. Also check that

the aileron can move freely and not bind at the wing root.

Note: Do not use CA accelerator during

the hinging process. The CA must be

allowed to soak into the hinge to provide

the best bond. Using accelerator will not

provide enough time for this process.

  Step 5

Remove the T-pins from the hinges. Flex the aileron and

apply Thin CA to each hinge. Make sure the hinge is fully

saturated with CA. Use a paper towel and CA remover/

debonder to clean up any excess CA from the wing and/or

aileron. Make sure to apply CA to both the top and bottom

of the hinge.

  Step 6

Firmly grasp the wing and aileron and gently pull on the

aileron to ensure the hinges are secure and cannot be

pulled apart. Use caution when gripping the wing and

aileron to avoid crushing the structure.

  Step 7

Flex each aileron up and down a number of times to

break in the hinges.

Section 1: Aileron Installation