User Manual

Section 8A: Engine Installation

Required Parts

• Fuselage assembly • Engine mount (2)

• 8-32 x 3/4" screw (4) • 3mm washer (4)

• 3mm x 20mm screw (4) • 3mm lock nut (4)

Required Tools and Adhesives

• Drill • Drill bit: 9/64"

• Engine • Pliers

• Clamp

• Phillips screwdriver (large)

Step 1

Attach the engine mount to the firewall using four

8-32 x 3/4" screws.

Step 2

Position the engine on the mount.Adjust the engine

so the distance from the firewall to the drive washer

is 4

". Use clamps to hold the engine in position.

Step 3

Mark the locations for the engine mounting bolts.

Step 4

Remove the engine and drill the locations marked in

the previous step using a 9/64" drill bit.

Hint: Use a drill press for the best results.

This makes holes perfectly perpendicular

(square) to the mount.

Step 5

Attach the engine using four 3mm x 20mm

socket head screws, four 3mm washers and

four 3mm lock nuts.