User Manual

Section 9: Throttle Pushrod Installation

Step 3

Slide a clevis retainer onto a nylon clevis.Thread a

clevis onto a 14

" wire, a minimum of 10 turns.

Step 4

Attach the clevis to the throttle arm on the

carburetor. Slide the pushrod wire into the pushrod

tube and re-install the engine. Bend the pushrod if

necessary so it moves freely.

Section 10: Fuel Tank Assembly

Required Parts

• Clunk (fuel pickup) • Metal caps (2)

• Fuel pickup tubing • Fuel tank

• Rubber stopper • M3 x 20 screw

• Metal tube (2)

Required Tools and Adhesives

• Hobby knife

• Phillips screwdriver (small)

Note:The stopper provided with the Twist™

has three holes that are not bored completely

through the stopper.The holes are for the

fuel pickup, fill and vent lines. For these

instructions, only two holes will be used: one

for the fuel pickup and one for the fuel vent.

Only open the third hole if you are going to

use a separate fill line.

Step 1

Locate the fuel tank parts.