User Manual

Section 2: Installing the Horizontal Stabilizer

Required Parts

• Wing • Fuselage

• Horizontal stabilizer • Elevator joiner wire

Required Tools and Adhesives

• Flat blade screwdriver • Sandpaper

• Felt-tipped pen • Paper towel

• Rubbing alcohol

Step 1

Slide the stab into the slot in the fuselage, with the

leading edge pushed forward in the slot. Center the

stab in the opening by measuring the distance from

the fuselage to each tip.The stab is aligned when

both measurements are identical.

Step 2

Check the distance from each stab tip to each wing

tip.These measurements must also be equal.

Step 3

The last alignment step is making sure the wing and

stabilizer are parallel. If they are not, lightly sand the

opening in the fuselage for the stab until the stab

rests parallel to the wing.

BB'

B=B'

A=A'

Equal Distances