User Manual

Programming Guide — JR™ XP8103

Press to reset Flap

input to Pot 6.

Current Flap Channel Input

Pot 6: Flap Knob

FLP.SW+PG: Flap Switch and Pot 6

Press either the (+) or (-)

key to select Pot 6 or

FLP.SW +P6.

SELECT

CH CH CLEARUP

Step 4. Assigning the flaps to the flap switch: In System

Setup Mode press the Up key until “Input Sel.” (Flap Input) appears

on the screen. Press the (+) key so that “FLP.SW+P6” appears in the

lower screen.

Channel Being Programmed

SPOI Throttle

AIL1 Aileron Right

ELEV Elevator

RUDD Rudder

AIL2 Aileron Left

FLAP Flap (Right)

AUX2 Flap (Left)

AUX3 Extra Channel (Aux3)

Use + or -

to change

(normal/reverse)

Channel Selection

(1-8)

Reset travel direction to

factory preset (normal)

SELECT

CH CH CLEARUP

Step 5. Setting servo reversing: Turn the transmitter off and then

back on again. Press the Up and Down keys simultaneously to access

the Function mode. Press the Up key until the “REV.SW” function

appears on the screen. Press the Channel key to select each channel

and check that the servo direction is operating correctly for each

channel. To change the direction of the selected channel, press the

(+) or (-) key. Check and adjust all channels as necessary.

Note: When the three-position flap switch is pulled down, the

flaps should come down. If they go up, reverse the direction of

channel 6 (FLAP) and or 7 (AUX 2).

Note: Because the GLID model programming is being used,

the transmitter refers to the throttle function as SPOI or

spoilers. Any time “SPO”I is displayed, it functions as throttle.