User Manual

Programming Guide — JR™ XP8103
67
At rate, press to
increase/decrease
mixing value (± 125%)
At switch, press to
change switch selection.
Function Selection
→Rates→Switch→Offset
Press to return the mixing
value to zero or to return the
active mixing switch ON.
DN
SELECT
CH CH CLEARUP
“SW OFF” appears when the flap mixing is in the
middle or upper position.
Flap to Aileron Mixing Value (± 125%).
Indicates current mixing switch activated
Flap Offset Value
Indicates the function
being selected:
Step 13. Flap-to-aileron mixing: Press the Up key until the mix
“FLAP-AILE” screen appears. Now press the CH key to move the cursor
to the SW: position (flap-to-aileron switch selection). Press the (+) key
until “FLP-D” (flap down) appears in the screen. Now press the CH key
twice to return the cursor to the RATE position. Move the flap switch to
the down position. Next press the (+) key until both the ailerons go
up 3/4". If the ailerons go down, press the (-) key.
Note: The flap switch must be in the down position to change
the rate value.
Step 12. Setting up Crow: Crow will be assigned to the flap switch
and will be activated when the switch is in the down position. We’ve
already set the flaps to the proper down position in Step 8 travel adjust.
Now we need to add the ailerons up 3/4" and the elevator down 1/4".
Flap Operating Direction
(D=Down, U=Up)
“SW Off” appears when the flap mixing is in the
middle or lower position
Flap to Elevator Mixing Value (± 125%)
Indicates current mixing switch activated
Flap Offset Value
At rate, press to
increase/decrease
mixing value (± 125%)
At switch, press to
change switch selection.
Press to return the
mixing value to zero or
to return the active
mixing switch to ON.
DN
SELECT
CH CH CLEARUP
Indicates the function
being selected:
Step 14. Flap-to-elevator mixing: In Function mode, press the
Up key until the mix “FLAP-ELEV” appears on the screen. Next press
the CH key to move the cursor to the SW (flap-to-elevator switch
selection) position. Press the (+) key until the “FLP-D” (flap down)
appears on the screen. Now press the CH key to return the cursor
to the “Rate” position. With the flap switch in the down position,
press the (+) key until the elevator comes down 1/4". If the elevator
goes up, use the (-) key to reverse this.
↓
Rate
↓
SW
↓
Rate
↓
SW
Function Selection
→Rates→Switch→Offset