User manual
16. Guide the leads for the battery and receiver through the hole in the
fuselage fi rewall.
17. Secure the batteries to the battery tray using the hook and loop
straps provided with the kit. We recommend applying hook and loop
tape to the battery tray and batteries to keep the batteries from
sliding when installed in the fuselage.
Do not cover safety warnings on the
battery with hook and loop tape.
18. Install the battery tray in the fuselage by fi tting the notch at the front
into the slot in the fi rewall. Use the nylon M4 x 20 screw to secure
the rear of the battery tray.
The test aircraft were flown without the addition of nose
weight using the following motor and battery combinations:
GAS ENGINE INSTALLATION
1. Prepare the stopper assembly by placing small amounts of solder on
the end of the tubes shown. This will help keep the fuel lines secure
when installed.
Use hemostats to act as a heat-sink to
avoid melting the rubber stopper.
2. Cut a piece of fuel tubing that will result in the end of the clunk
being 5 inches (127mm) from the back of the aluminum plate.
Secure the tubing to the clunk and stopper using thin wire. This will
keep the tubing from sliding loose inside the tank. Make sure to use
the clunk supplied with your engine.
A second clunk can be installed to provide
a line to fuel/defuel your aircraft.
4. Mark the lines from the tank so the fuel lines can be identifi ed from
outside the tank. Tighten the screw in the stopper using a #1 Phillips
screwdriver.
Check that both clunks can move freely inside the tank.
If not, adjust the tubing from outside the tank so they can
move freely to ensure consistent fuel flow to the engine.
5. Secure an 8-inch (200mm) fuel line to the fi ll, vent and clunk tubes
of the fuel tank. Tie wraps can also be used to secure the fuel lines
as an alternative to wire ties.
3. Insert the clunks into the tank. Install the larger clunk, then the small
clunk.
28EN
Motor Propeller Battery
Rimfi re 65 cc 24x10 6S 7000mAh x2
Rimfi re 160/170 20x8 or 20x10
5S 5000mAh x4
* Two packs in
parallel to equal 10s
10000mAh