Specifications

- 16 -
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This product has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This product generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this product does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
OEM requirement and guidance for host manufactures
The module is limited to OEM installation ONLY
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
In case that FCC identification number and IC identification number is not visible when the
module is installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label can use
wording such as the following: “Contains FCC ID: 2ATEV-BL1206-P” and “Contains IC:
25062-BL1206P “the information should be also contained in the devices’ user manual.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. The devices must be installed and used in
strict accordance with the manufacturer’s instructions as described in the user documentation
that comes with the product. This device is intended only for OEM integrators under the
followingconditions:1) The antenna must be installed such that 20 cm is maintained between the
antenna and user.2) The transmitter module may not be co-located with any other transmitter or
antenna.
This equipment complies with FCC &IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.