User's Manual

Appendix

HDD Installation

1. (Optional) Remove the rubber mats.

2. Loosen four screws on the bottom of the device to take apart the base, see figure below.

3. Stick the thermal conductive silicon pads to both sides of the HDD, and attach the HDD radiator to the

silicone pads.

4. Use the four screws to secure the radiator to the HDD, see figure below.

5. Connect the data cable. Make sure the limit line (white) aligns with the connector edge.

6. Install the HDD shield. See figure below., see figure below.

7. Re-assemble the base of the VAULT Plus. Replace the screws and rubber mats to complete the HDD

installation.

Thermal Conductive Silicon Pad

HDD Radiator

Limit Line