User's Manual
3
Insulation Strip
• After removing the insulation strip, before performing any operations, please wait
about 2-3 minutes, which will make the PIR detection performance more stable.
• When the battery level is low, the low battery notication will be pushed to the
EZVIZ app to remind you to replace batteries.
• If you need to replace batteries, please purchase CR2450 620mAh batteries.
• When replacing batteries, please insert with the positive side facing up.
Add Device
The detector should be used along with EZVIZ Smart Gateway (afterinafter referred to as
"gateway"). Please add gateway to the EZVIZ cloud, and then add the detector to the gateway
by the following two methods.
1. Method One: Add by Scanning QR Code
1. Log in to your account through EZVIZ app, tap the device adding icon and
then the QR code scanning interface will be displayed.
2. Scan the QR code on the inner side of the cover or on the user manual, and
then add the detector to the gateway.
Scan QR Code
3. Rotate the cover clockwise until the installation instruction mark and the
EZVIZ logo are aligned.
2. Method Two: Add by the Gateway
When adding detector by the gateway, place the detector as close to the gateway as
possible.
1. Make the gateway enter device adding mode as instructed by the user
manual of the gateway
2. Press and hold the RESET button for over 5 seconds until the indicator on the
detector turns fast-flashing blue, and then the detector will enter adding mode.
3. The detector will be added to the gateway automatically, and the LED
indicator will be off.
4. Rotate the cover clockwise until the installation instruction mark and the
EZVIZ logo are aligned.