User's Manual

Table Of Contents

Successively dismantle the tire, screw out

the valve core of tire valve and make the tire

deflated.

Loosen outer surface of the tire toward to the

tire valve with tire changer and then loosen

the inner surface of the tire. Strip the tire

from the wheel frame.

Dismantle the original tire valve on wheel

frame.

Clean up the hole of wheel frame and inner surface of wheel frame, so as to

remove the impurity and dirt (it is suggested that coat a thin layer of soapy

water or silicone oil on the hole of wheel frame).

Select the sensor in corresponding location in accordance with installation

location of the tire.

If the sensor with impact aluminium tire valve is

used, screw out the nut firstly. Then make the

tire valve of the sensor pass through the hole of

wheel frame from inside to outside. During

installation, make sure that the rubber gasket

and the hole of tire frame are perfectly matched

and the plane of the sensor is parallel to wheel

frame. Finally, screw down the nut. The nut

shall be made to the required torque rating with

socket sets used for settings on torque value.

The defined torque value of Hamaton sensor is

44.25ibf-in or 5N.m.

If the sensor with clip-on rubber tire valve is

used, utilize professional tool for tire valve to

pull tire valve and sensor into the hole of wheel

frame. Pay attention to protect sensor while

pulling in. After pull them into the hole, make sure that the plane of the sensor

is parallel to wheel frame and the hole of tire frame in the locating ring of the

tire valve is wholly exposed.

* Professional tire installation and maintenance equipment is required for the

sensors of the system. Therefore, it is suggested that you go to professional

tire shops for installation.

STEP

Installation of Sensor

STEP

Paint lubricating agent on contact surface

between tire and wheel frame. Then assemble

the tire into wheel frame.

Installation of Sensor