User's Manual

11
12
Positioning Settings of Sensor Positioning Settings of Sensor
* While newly installing the sensors, it is required to separately install them into
the corresponding tires in accordance with "left front", "right front", "left rear"
and "right rear" marked on the sensors. In case of changes in position of tires
or exchanges of sensors, it is required to again carry out positioning settings on
sensors in four tires.
1. Press "OK" key to enter the main menu;
2. Press "SEL" key to select the option of
"sensor settings"
3. Press "OK" key to enter settings on the left
front sensor;
4. Then screw out the valve cap of the left front wheel
and quickly make the tire deflated with opening valve
core. After the pressure data of the left front wheel is
shown on the receiving display, stop bleeding gas;
5. The system will automatically
switch to the setting interface for
the right front wheel;
6. Then screw out the valve cap of the right
front wheel and quickly make the tire deflated
with opening valve core. After the pressure
data of the right front wheel is shown on the
receiving display, stop bleeding gas;
SENSOR SETTING
Left Front
SENSOR SETTING
Left Front
26 °C
2.5 Bar
SENSOR SETTING
Right Front
SENSOR SETTING
Successful
SENSOR SETTING
Fail
11. The setting interface will show "Successful sensor
setting".
12. It will return back to the main interface after fifteen
seconds or with pressing any key. The positioning
setting is finished. Supplement each tire pressure to
the standard tire pressure and then screw down valve
caps of each tire.
In case of pressing "ESC" key during any step, the system will not save
and will quit sensor settings.
Remark: the customer that has Hamaton diagnostic tools can use it to
carry out positioning setting of sensor. For operating methods, please
refer to the operation instruction for Hamaton diagnostic tool.
SENSOR SETTING
Right Rear
SENSOR SETTING
Right Rear
2.5 Bar
26 °C
7. The system will automatically
switch to the setting interface
for the right rear wheel;
8. Then screw out the valve cap of the right
rear wheel and quickly make the tire deflated
with opening valve core. After the pressure
data of the right rear wheel is shown on the
receiving display, stop bleeding gas;
If the setting interface show "fail sensor setting", it
is required to press "ESC" key to return to the
main interface. Then repeat the above-mentioned
steps to again carry out positioning settings of
sensor.
SENSOR SETTING
Left Rear
SENSOR SETTING
Left Rear
2.5 Bar
26 °C
9. The system will automatically
switch to the setting interface for
the left rear wheel;
10. Then screw out the valve cap of the left rear
wheel and quickly make the tire deflated with
opening valve core. After the pressure data of
the left rear wheel is shown on the receiving
display, stop bleeding gas;
PRESSURE UNIT SETTING
TEMPERATURE UNIT SETTING
DISPLAY TIME SETTING
SENSOR SETTING
SENSOR SETTING
Right Front
2.5 Bar
26 °C