Video Conference PTZ Camera
Packing List Battery Power Adapter Camera Remote Control Quick Start Guide Bracket Screws Extension Cable USB Cable
Functions Supports four modes. The image flips as the following order every time pressing the button. "F" is the default status. Image Flip Mute Turn on/off the audio of the remote control or the camera. One-touch Focus Adjust the focus manually. Zoom in/out Pan/tilt the camera Press the button to adjust the camera by level. Press and hold the button to adjust the camera continuously. Focus Zoom in/out Press the button to adjust the camera by level.
Indicator Microphone If the preset 0 is predefined, the camera moves to the set position after powering on. If not, the camera moves to the default position after powering on. 1. Adjust the image by remote control. 2. Press and hold a preset number for 3 seconds, and the indicator flashes twice. It means the preset is successfully set. Default Preset Presets 3. Press the preset number, and the device return to the defined position. Up to 6 presets can be set.
Microphone Lens Indicator Kensington Lock Power Interface USB Type C 1/4-20UNC Screw Hole Lashing Eye The lock shall be purchased When the indicator turns to red, it means the device is standby. When the indicator turns to blue, it means the device is working normally.
Connection USB Cable Extension Cable Power Adapter
Installation Table Mounting
Wall Mounting
Others
Angle Adjustment
©2021 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved. About this Manual The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version of this Manual at the Hikvision website (https://www.hikvision.com/).
Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Safety Instruction Warings Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Electrical Safety The socket-outlet shall be installed near the equipment and shall be easily accessible. Battery CAUTION: Risk of explosion if the battery is replaced by an incorrect type. Improper replacement of the battery with an incorrect type may defeat a safeguard (for example, in the case of some lithium battery types).
Cleaning Please use a soft and dry cloth to clean the interior and exterior surfaces. Do not use alkaline detergents. Using Environment When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it may burn out. DO NOT aim the lens at the sun or any other bright light. To avoid heat accumulation, good ventilation is required for a proper operating environment. DO NOT expose the device to extremely hot, cold, dusty, corrosive, saline-alkali, or damp environments.
UD25880B