Camera Network Mini PT Dome Camera Quick Start Guide UD.
Network Mini PT Dome Camera·Quick Start Guide Quick Start Guide COPYRIGHT © 2015 Hangzhou Hikvision Digital Technology Co., Ltd. ALL RIGHTS RESERVED. Any and all information, including, among others, wordings, pictures, graphs are the properties of Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries (hereinafter referred to be “Hikvision”).
Network Mini PT Dome Camera·Quick Start Guide Legal Disclaimer TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THE PRODUCT DESCRIBED, WITH ITS HARDWARE, SOFTWARE AND FIRMWARE, IS PROVIDED “AS IS”, WITH ALL FAULTS AND ERRORS, AND HIKVISION MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT OF THIRD PARTY.
Network Mini PT Dome Camera·Quick Start Guide IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS. Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Network Mini PT Dome Camera·Quick Start Guide 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.
Network Mini PT Dome Camera·Quick Start Guide Cet appareil est conforme à la section 15 des réglementations de la FCC. Le fonctionnement de l’appareil est sujetaux deux conditions suivantes : (1) cet appareil ne doit pas provoquer d’interférences néfastes, et (2) cet appareil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un fonctionnement indésirable.
Network Mini PT Dome Camera·Quick Start Guide Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Network Mini PT Dome Camera·Quick Start Guide radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Network Mini PT Dome Camera·Quick Start Guide Warnings Follow these safeguards to prevent serious injury or death. Cautions Follow these precautions to prevent potential injury or material damage. Warnings ● Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user. ● In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region.
Network Mini PT Dome Camera·Quick Start Guide ● Make sure the power supply voltage is correct before using the camera. ● Do not drop the camera or subject it to physical shock. ● Do not touch sensor modules with fingers. If cleaning is necessary, use clean cloth with a bit of ethanol and wipe it gently. If the camera will not be used for an extended period, please replace the lens cap to protect the sensor from dirt. ● Do not aim the camera at the sun or extra bright places.
Network Mini PT Dome Camera·Quick Start Guide and using history, so regular checking is recommended for all the users. Please contact with your dealer for more details. ● Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of used batteries according to the instructions provided by the battery manufacturer. ● If the product does not work properly, please contact your dealer or the nearest service center.
Network Mini PT Dome Camera·Quick Start Guide Table of Contents 1 Appearance Description ............................................................... 13 Overview ....................................................................... 13 Installing SD / SIM Card ................................................. 19 Remote Control ............................................................. 20 2 Installation ....................................................................................
Network Mini PT Dome Camera·Quick Start Guide 1 Appearance Description Overview Two types of network Mini PT cameras are shown below. Type I: WiFi network transmission is supported for the Type I network Mini PT camera.
Network Mini PT Dome Camera·Quick Start Guide 15 16 11 14 12 13 Overview (3)-Type I Description of Type I Network Mini PT Camera No.
Network Mini PT Dome Camera·Quick Start Guide No. Description 12 Alarm Input/output Interface 13 Reset 14 Audio Out 15 Power supply interface (5 VDC) 16 Speaker Solid blue: Network is connected, and camera is unarmed. Flicking blue: No network connection. 17 Status LED Solid red: Camera is armed. Flicking red: Camera is not working properly. Solid green: Camera is connected to the platform.
Network Mini PT Dome Camera·Quick Start Guide Type II: Wireless alarm is supported for the Type II network Mini PT camera. 4G and Wi-Fi network transmission are optional. 2 1 3 4 Overview (1)-Type II 5 6 7 8 10 9 Overview (2)-Type II For the Type II network Mini PT camera supporting the 4G network transmission, the Wi-Fi network transmission does not take effect.
Network Mini PT Dome Camera·Quick Start Guide 15 17 14 16 11 12 18 13 Overview (3)-Type II Description of Type II Network Mini PT Camera No.
Network Mini PT Dome Camera·Quick Start Guide No. Description 12 10M / 100M self-adaptive Ethernet interface 13 Audio Out 14 WPS(Wi-Fi Protected Setup) Button, (optional) 15 Power supply interface (5 VDC) 16 Reset 17 Speaker Solid blue: Network is connected, and camera is unarmed. Flicking blue: No network connection. Solid red: Camera is armed. 18 Status LED Flicking red: Camera is not working properly. Solid green: Camera is connected to the platform and unarmed.
Network Mini PT Dome Camera·Quick Start Guide You can disable the status LED when you access the camera via browsers. Go to Configuration—Advanced Configuration—System—Service, and check off the checkbox of Enable Status LED to disable the status LED. Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, port No., etc. A wireless router with the WPS function is required to enable the WPS function of the camera.
Network Mini PT Dome Camera·Quick Start Guide Removable Cover Micro SD Card SIM Card Install SD / SIM Card Remote Control A remote control is supplied for the Type II network Mini PT camera.
Network Mini PT Dome Camera·Quick Start Guide Description of Remote Control Button Arm Button Disarm Button Emergency Button Privacy Button Description Press the button to arm the camera. In arming status, the alarm function, such as the wireless alarm and the PIR alarm is enabled. Press the button to disarm the camera. In the disarming status, the alarm linkage is disabled. Long press the button for 2s to trigger the emergency alarm. The emergency alarm has the highest priority.
Network Mini PT Dome Camera·Quick Start Guide 2 Installation Before you start: ● Make sure the device in the package is in good condition and all the assembly parts are included. ● The standard power supply is 12V DC or 24V AC, please make sure your power supply matches with your camera. ● Make sure all the related equipment is power-off during the installation. ● Check the specification of the products for the installation environment.
Network Mini PT Dome Camera·Quick Start Guide Steps: Drill the screw holes on the ceiling according to the supplied drill template. Drill Template Align the screw holes on the ceiling and adapter plate, and then fix the adapter plate to the ceiling with the supplied screws.
Network Mini PT Dome Camera·Quick Start Guide Bayonet Joint Install the Adapter Plate For cement wall, you need to use the expansion screw to fix the mount; for wooden wall, you can just use the self-tapping screw to fix the mount. Align the mounting base of the camera to the adapter plate, and rotate the camera clockwise until it is locked up by the three bayonet joints on the adapter plate.
Network Mini PT Dome Camera·Quick Start Guide OPEN LOCK Install the Camera Adjust surveillance view angle. 1) Hold and rotate the main camera body to adjust the view angle in the pan direction: [0°~355°]. 2) Move the dome drive upwards or downwards to adjust the view angle in the tilt direction: [-20°~90°].
Network Mini PT Dome Camera·Quick Start Guide Pan: 0°~355° Camera Body Dome Drive Tilt: -20°~90° Adjust the View Angle Table mounting is also available for the network Mini PT camera. If the camera needs to be fixed on the table, refer to the above steps described for the ceiling mounting; if not, just place the camera on the table.
Network Mini PT Dome Camera·Quick Start Guide 3 Setting the Network Camera over the LAN Note: You shall acknowledge that the use of the product with Internet access might be under network security risks. For avoidance of any network attacks and information leakage, please strengthen your own protection. If the product does not work properly, please contact with your dealer or the nearest service center.
Network Mini PT Dome Camera·Quick Start Guide Activating the Camera You are required to activate the camera first by setting a strong password for it before you can use the camera. Activation via Web Browser, Activation via SADP, and Activation via Client Software are all supported. We will take activation via SADP software and Activation via Web Browser as examples to introduce the camera activation. Please refer to the User Manual of Network Camera for Activation via Client Software.
Network Mini PT Dome Camera·Quick Start Guide Activation Interface(Web) 3. Create a password and input the password into the password field. STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong password of your own choosing (using a minimum of 8 characters, including upper case letters, lower case letters, numbers, and special characters) in order to increase the security of your product.
Network Mini PT Dome Camera·Quick Start Guide Activation via SADP Software SADP software is used for detecting the online device, activating the camera, and resetting the password. Get the SADP software from the supplied disk or the official website, and install the SADP according to the prompts. Follow the steps to activate the camera, please refer to the User Manual of Network Camera for other two activation methods. Steps: 1. Run the SADP software to search the online devices. 2.
Network Mini PT Dome Camera·Quick Start Guide 3. Create a password and input the password in the password field, and confirm the password. STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong password of your own choosing (using a minimum of 8 characters, including upper case letters, lower case letters, numbers, and special characters) in order to increase the security of your product.
Network Mini PT Dome Camera·Quick Start Guide Note: Please refer to Chapter 3.2 to activate the camera if the camera is inactive. 3. Change the device IP address to the same subnet with your computer by either modifying the IP address manually or checking the checkbox of Enable DHCP. Modify the IP Address 4. Input the password to activate your IP address modification. The batch IP address modification is supported by the SADP; please refer to the User Manual of SADP for details.
Network Mini PT Dome Camera·Quick Start Guide 4 Accessing via Web Browser System Requirement: Operating System: Microsoft Windows XP SP1 and above version CPU: 2.0 GHz or higher RAM: 1G or higher Display: 1024×768 resolution or higher Web Browser: Internet Explorer 8.0 and above version, Apple Safari 5.0.2 and above version, Mozilla Firefox 5.0 and above version and Google Chrome 18 and above version Steps: 1. Open the web browser. 2.
Network Mini PT Dome Camera·Quick Start Guide 4. Click Login. Login Interface 5. Install the plug-in before viewing the live video and managing the camera. Please follow the installation prompts to install the plug-in. You may have to close the web browser to finish the installation of the plug-in.
Network Mini PT Dome Camera·Quick Start Guide Download Plug-in Install Plug-in (1) 35
Network Mini PT Dome Camera·Quick Start Guide Install Plug-in (2) 6. Reopen the web browser after the installation of the plug-in and repeat steps 2~4 to login. For detailed instructions of further configuration, please refer to the user manual of network camera.
0
