User's Manual

7.2 Communicaon Sengs
Support Wi-Fi, ISUP and remote conguraion via mobile browser.
7.2.1 Set Wi-Fi Parameters
You can enable the Wi-Fi funcon and set the Wi-Fi related parameters.
Steps
Note
The
funcon should be supported by the device.
1. T
ap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap Wi-Fi.
3. Enable the Wi-Fi funcon.
4. Congure the Wi-Fi parameters.
-
Select a Wi-Fi from the list, and enter the Wi-Fi's password. Tap OK.
-
If the target Wi-Fi is not in the list, tap Add Wi-Fi. Enter the Wi-Fi's name and password. And
tap OK.
Note
• If the mobile phone remote conguraon is enabled, the Wi-Fi funcon will be disabled.
•
Only digits, leers,
and special characters are allowed in the password.
5. Se
t the Wi-Fi's parameters.
-
By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the
gateway automacally.
-
If disable DHCP
, you should enter the IP address, the subnet mask, and the gateway
manually.
6. Tap OK to save the sengs and go back to the Wi-Fi tab.
7. Tap
to save the network parameters.
7.2.2 Set ISUP Parameters
Set ISUP parameters and the device can upload data via ISUP protocol.
Be
fore You Start
Make sure your device has connect to a network.
Steps
1. Tap Comm. → ISUP .
DS-K1A340 Series Face Time Aendance Terminal User Manual
18