User's Manual

7.6.1 Authencate via Single Credenal
Set the user authencaon type before authencaon. For details, see Set Authencaon Mode .
Authencate
face, ngerprint, card or QR code.
Face
Face forward at the camera and start authencaon via face.
Fing
erprint
Place the enrolled ngerprint on the ngerprint module and start authencaon via ngerprint.
Password/Pin Code
Enter the password/pin code to authencate via password.
Note
Password should be congured in the plaorm.
If
authencaon completed, a prompt "Authencated" will pop up.
Tap , enter the password and tap OK.
7.6.2 Authencate via Mulple Credenal
Before You Start
Set the user authencaon type before authencaon. For details, see Set Authencaon Mode .
Steps
1. If the
authencaon mode is Face, Password and Face, Password, Face and Fingerprint,
authencate any credenal according to the instrucons on the live view page.
Note
• Some devices support ngerprint
authencaon. Refers to the actual device for details.
• Support, face + ngerprint, face + pin, ngerprint + pin, face + ngerprint + pin authencaon
methods.
2. Aer the previous credenal is authencated,
connue authencate other credenals.
Note
• For detailed informaon about scanning ngerprint, see Tip
s for Scanning Fingerprint.
• For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If authencaon succeeded, the prompt "Authencated" will pop up.
DS-K1A340 Series Face Time Aendance Terminal User Manual
40