User's Manual

Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Enable Tampering Detecon
Enable the an-tamper detecon for the card reader.
Enable Card No. Reversing
The read card No. will be in reverse sequence aer enabling the funcon.
Communicaon with Controller Every (s)
When the access control device cannot connect with the card reader for longer than the set
me, the card reader will turn oine automacally.
Max. Interval When Entering Password (s)
When you entering the password on the card reader, if the interval between pressing two
digits is longer than the set value, the digits you pressed before will be cleared automacally.
Authencaon
Select an authencaon mode according to your actual needs from the drop-down list.
Display Authencaon Result
Check Face Picture, Name, or Employee ID. When authencaon is completed, the system
will display the selected contents in the result.
Name
De-idencaon
The name informaon is desensized with an asterisk.
Name De-idencaon
The ID informaon is desensized with an asterisk.
Recognion Interval
If the in
terval between card presenng of the same card is less than the congured value,
the card presenng is invalid. The interval me range is from 0 to 255 seconds (When set to
0, it means that recognion interval is not enabled, and the same authencaon can be used
f
or unlimited mes).
8.3.8 Face Parameters Sengs
Set face parameters.
Face Parameters Sengs
Tap Conguraon → Smart → In
telligent Parameter to enter the page.
Note
The
funcons vary according to dierent models. Refers to the actual device for details.
Set Face Parameters.
DS-K1A340 Series Face Time Aendance Terminal User Manual
59