User's Manual

Steps
Note
The
funcon should be supported by the device.
1. Click Conguraon → Ne
twork → Advanced Sengs → Plaorm .
2. Select ISUP from the plaorm access mode drop-down list.
3. Check Enable.
4. Set the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5. Click Sa
ve.
Enable SDK Service
Aer enabling SDK service, the device can be connected to the SDK server.
Click Conguraon → Network → Advanced → Network Service to enter the sengs page.
Check the checkbox of Enable to enable the funcon.
Click Sa
ve to enable the sengs.
9.4.13 Set Video and Audio Parameters
Set the output volumn and voice prompt.
Click Conguraon → Video/Audio → Audio .
Drag the block to adjust the output volumn.
Enable Voice Prompt, and the device will make voice prompts.
Click Save to save the sengs aer the
conguraon.
Note
The
funcons vary according to dierent models. Refers to the actual device for details.
9.4.14 Customize Audio Content
Customize the output audio content when authencaon succeeded and failed.
St
eps
1. Click Conguraon → Video/
Audio → Prompt .
DS-K1A340 Series Face Time Aendance Terminal User Manual
71