User's Manual

Steps
Note
It should be supported by the device.
1. Click Access Con
trol → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add buon to add a new linkage.
4. Select the event source as Event Linkage.
5. select the event type and detailed event to set the linkage.
6. In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible w
arning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Access Point
The door status of open, close, remain open, and remain close will be triggered.
Note
The target door and the source door cannot be the same one.
7. Click Sa
ve.
8. Oponal: Aer adding the device linkage, you can do one or more of the following:
Edit Linkage
Sengs
Select the
congured linkage sengs in the device list and you can edit
its event source parameters, including event source and linkage target.
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete
to delete it.
7.8.3 Congure Device Acons for Card Swiping
You can set the access control device's linkage acons for the specied card swiping. When you
swipe the specied card, it can trigger the host buzzer, and other acons on the same device.
Steps
Note
It should be supported by the device.
1. Click Access Con
trol → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add buon to add a new linkage.
4. Select the event source as Card Linkage.
Access Control Terminal User Manual
87