User's Manual

Capture
An event-related picture will be captured when the selected event happens.
Recording
An event-related picture will be captured when the selected event happens.
Note
The device should support recording.
Access Point
The door s
tatus of open, close, remain open, or remain closed will be triggered.
8. Click Save.
9. Oponal: Aer adding the device linkage, you can do one or more of the followings:
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete
to delete it.
Edit Linkage
Sengs
Select the
congured linkage sengs in the device list and you can edit
its event source parameters, including event source and linkage target.
7.9 Door Control
In Monitoring module, you can view the real-me status of the doors managed by the added
access control device. You can also control the doors such as open/close the door, or remain the
door open/closed via the client remotely. The real-me access event are displayed in this module.
You can view the access details and person details.
Note
For the user with door control permission, the user can enter the Monitoring module and control
the door
. Or the icons used for control will not show. For seng the user permission, refer to
Person Management .
7.9.1 Control Door Status
You can control the status for a single door, including opening door, closing door, remaining the
door open, and r
emaining the door closed.
Steps
1. Click Monitoring to enter the status monitoring page.
2. Select an access point group on the upper-right corner.
Access Control Terminal User Manual
89