User's Manual

On the Device for Management page, click → Network → Report Strategy to enter the Report
Strategy Sengs tab.
You can set the center group and the system will transfer logs via EHome protocol. Click Save to
save the sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
7.12.9 Network Center Parameters Sengs
You can set the nofy surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome acc
ount user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click Remote Conguraon → Network → Network Center
Parameters to enter the Network Center Parameters Sengs tab.
Select a center from the drop-down list.
Aer enabling the funcon, you can set the center's address type, IP address/domain name, and
port No., cr
eate EHome user name, etc.
Note
If set the EHome type as EHome5.0, you should create an EHome key as well.
Click Sa
ve.
Aer creang the EHome informaon, you can add the device via EHome protocol.
7.12.10 Congure
Wi-Fi
Steps
1. On the Device for Management page, click
→ Network → Wi-Fi t
o enter the Wi-Fi Sengs
tab.
2. Check Enable to enable the Wi-Fi funcon.
3. En
ter the SSID name and password or you can select a network from the Wi-Fi list.
4. Set the Wi-Fi Security Mode from the drop-down list.
5. Oponal: Click Refresh to refresh the network status.
6. Oponal: Set WLAN parameters.
1) On the Wi-Fi Sengs page, click WLAN t
o enter the WLAN page.
2) Uncheck DHCP and set the IP address, the subnet mask, the default gateway, the MAC
address, the DNS1 IP Address, and the DNS2 IP address.
Access Control Terminal User Manual
121