User's Manual

7. Click Save.
7.12.11 Set Relay Parameters
Click Main
tenance and Management → Device to enter the device list.
Click
to enter the remote conguraon page.
Click Alarm → R
elay . Select a relay and click
and set the relay name and output delay me.
Click OK to save the sengs.
7.12.12 Set Access Control Parameters
Steps
1. On the De
vice for Management page, click
→ Others → Access Control Parameters to enter
the Access Control Parameters tab.
2. Check the checkbox to enable the funcon.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
3. Click Sa
ve.
7.12.13 Set CPU Card Reading Mode
Steps
1. On the Device for Management page, click
→ Others → CPU Car
d Reading Sengs to enter
the CPU Card Reading
Sengs tab.
2. Select a reading mode from the dropdown list.
3. Click Save.
7.12.14 Congure Volume Input or Output
Steps
1. On the De
vice for Management page, click
→ Image → Audio Input or Output t
o enter
Audio Input or Output tab.
2. Move the block to adjust the device output volume.
3. Click Save.
7.12.15 Operate Relay
Steps
1. Click Main
tenance and Management → Device to enter the device list.
Access Control Terminal User Manual
122