User's Manual

Figure 6-4 EHome Sengs
2. Enable the EHome funcon and set the EHome server parameters.
Cen
ter Group 1
Enable center group 1 and the data will be uploaded to the center group.
EHome
Enable EHome funcon and the data will be uploaded via EHome protocol.
Address Type
Select an address type according to your actual needs. If you select domain name, you
should congure the domain name.
IP Addr
ess
Set the EHome server's IP address.
Port No.
Set the EHome server's port No.
Domain Name
Set the domain name of EHome server.
EHome Version
Set the EHome version according to your actual needs. If you choose V5.0, you should create
an account and EHome key. If you choose other version, you should create an EHome
account only.
Note
• Remember the EHome account and EHome key. You should enter the account name or the
k
ey when the device should communicate with other plaorms via EHome protocol.
• EHome key range: 8 to 32 characters.
3. Press * and select Yes to save the sengs and exit the page.
Access Control Terminal User Manual
27