User's Manual

Note
• The card No. is required.
•
Up to 20 digits can be contained in the card No.
• The card No. can be 0.
• The card No. can start with 0 when it contains more than one numbers. E.g. 012345.
• The card No. should be unique.
FP (Fingerprint)
On the Fing
erprint page, select a target nger and record according to the voice prompt.
Note
• The same ngerprint cannot be repeatedly added.
•
Up to 10 ngerprints can be added to one user.
• You can also scan the ngerprints via the external ngerprint recorder and apply the
ngerprints to the device by the client soware.
• For detailed informaon about scanning the ngerprint, see Tips for Scanning Fingerprint .
• Parts of device models supports the ngerprint funcon.
Dept. (Department)
Select a departmen
t in the list and edit the department.
Note
For detailed informaon about eding the department, see .
Auth.
Select an authencaon mode when verifying user's permission.
Note
• If you select the authencaon mode as Con
troller, you should set the authencaon
mode in Set System Parameters . The system will authencate user's identy according to
the congured authencaon mode. By default, the authencaon mode is Controller.
This mode is applicable to edit users' authencaon modes in batch.
• If an user needs to use a special authencaon mode, which is dierent from the
authencaon mode congured in Set System Parameters , he can use card/ngerprint,
card, etc. The system will authencate the user's identy according to the congured
authencaon mode rst. This mode is applicable to edit single user's authencaon
mode, which has special permissions.
Role
Select the user's r
ole as administrator or normal user.
• Admin: The admin has all permissions to operate the device.
• User: The normal user can check aendance on the inial page.
Access Control Terminal User Manual
31