User's Manual

• Do not power o during the device upgrading.
• Aer the upgrading is completed, remove the USB ash drive.
-
Online upgr
ade: The system will gain the upgrade package from the plaorm to upgrade.
6.7.4 Restore Sengs
Restore system parameters to factory sengs or default sengs.
Steps
1. Move the cursor and select System → Reset .
2. Press * to enter the Reset page.
Figure 6-11 Reset Page
3. Select F
actory Sengs or Default Sengs .
Factory Sengs
All parameters of the device will restore to the factory parameters.
De
fault Sengs
All parameters, excluding the communicaon parameters, the remote user management,
and events, will restore to the factory parameters.
4. Press * to conrm the
sengs in the prompt page and the device starts restoring.
6.7.5 Data Transfer
You can export the access control parameters (ngerprint and user informaon) and the
aendance data (data aer
aendance, card swiping data for instance). You can also import the
access control parameters from the USB ash drive.
Export Data
Move the cursor and select Transfer → Export to enter the Export page.
Access Control Terminal User Manual
37