User's Manual

3. Click Add to open the Add window.
4. Select IP Segment as the adding mode.
5. Enter the required informaon.
Start IP
En
ter a start IP address.
End IP
Enter an end IP address in the same network segment with the start IP.
Port
Enter the device port No. The default value is 8000.
User Name
By default, the user name is admin.
Password
Enter the device password.
Cauon
The password strength of the device can be automacally checked. We highly recommend
y
ou change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case leers, lower case leers, numbers,
and special characters) in order to increase the security of your product. And we recommend
you change your password regularly, especially in the high security system, changing the
password monthly or weekly can beer protect your product.
Proper conguraon of all passwords and other security sengs is the responsibility of the
installer and/or end-user.
6. Oponal: Check S
ynchronize Time to synchronize the device me with the PC running the client
aer adding the device to the client.
7. Oponal: Check Import to Group to create a group by the device name.
Note
You can import all the channels of the device to the corresponding group by default.
8. Finish adding the de
vice.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the sengs and connue to add other device.
9. Oponal: Click
on Operaon column to view device status.
Add Device by EHome Account
For access control devices supports EHome 5.0 protocol, you can add them to the client by EHome
pr
otocol aer entering device ID and key, if you have congured their server addresses, port No.,
and de
vice IDs.
Access Control Terminal User Manual
50