User's Manual

1) Select the access group(s) to apply to the access control device.
To select mulple access groups, you can hold the Ctrl or Shi key and select access groups.
2) Click Apply All to Devices to start applying all the selected access group(s) to the access
control device or door staon.
Cauon
• Be careful to click Apply All t
o Devices, since this operaon will clear all the access groups
of the selected devices and then apply the new access group, which may brings risk to the
devices.
• You can click Apply Changes to Devices to only apply the changed part of the selected
access group(s) to the device(s).
3) View the apply status in the Status column or click Applying St
atusto view all the applied
access group(s).
The selected persons in the applied access groups will have the authorizaon to enter/exit the
selected doors/door staons with their linked card(s) or ngerprints.
9. Oponal: Click
to edit the access group if necessary.
7.7 Congure Advanced Funcons
You can congure
the advanced funcons of access control to meet some special requirements in
dierent scene.
Note
• For the card related funcons(the type of access control card), only the card(s) with access group
applied will be lis
ted when adding cards.
• The advanced funcons should be supported by the device.
• Hover the cursor on the Advanced Funcon, and then Click
to customize the advanced
funcon(s) to be displayed.
7.7.1 Congure Device Parameters
Aer adding the access control device, you can congure the parameters of access control device,
access c
ontrol points.
Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its parameters, including overlaying user
informaon on picture, uploading pictures aer capturing, saving captured pictures, etc.
St
eps
1. Click Access Control → Advanced Funcon → De
vice Parameter .
Access Control Terminal User Manual
69