User's Manual

Note
If you can nd Device Parameter in the Advanced Funcon list, Hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2. Select an access de
vice to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding funcons.
Note
• The displayed parameters may vary for dierent access control devices.
•
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Voice Prompt
If y
ou enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
Enable NFC Card
If enable the funcon, the device can recognize the NFC card. You can present NFC card on
the device.
Enable M1 Card
If enable the funcon, the device can recognize the M1 card. You can present M1 card on the
de
vice.
Enable EM Card
If enable the funcon, the device can recognize the EM card. You can present EM card on the
de
vice.
Enable CPU Card
Reserved. If enable the funcon, the device can recognize the CPU card. You can present CPU
c
ard on the device.
Enable ID Card
Reserved. If enable the funcon, the device can recognize the ID card. You can present ID
c
ard on the device.
4. Click OK.
5. Oponal: Click Cop
y to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door
Aer adding the access control device, you can congure its access point parameters.
Steps
1. Click Access Control → Advanced
Funcon → Device Parameter .
Access Control Terminal User Manual
70