User's Manual

7. Click Save.
Create EHome Account in Wired Communicaon Mode
You can set the account for EHome protocol in wired communicaon mode. Then you can add
de
vices via EHome protocol.
Steps
Note
• This funcon should be supported by the device.
•
Make sure the device is not added by EHome.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and enter Network → Network Center .
4. Select the center group from the drop-down list.
5. Select the Address Type as IP Address or Domain Name.
6. Enter IP address or domain name according to the address type.
7. Enter the port number for the protocol.
Note
The port number of the wireless network and wired network should be consistent with the port
number of EHome.
8. Select the Pr
otocol Type as EHome and select EHome version.
Note
If set the EHome version as 5.0, y
ou should create an EHome key for the EHome account.
9. Se
t an account name for the network center.
10. Click Save.
Enable M1 Card Encrypon
M1 card
encrypon can improve the security level of authencaon.
Steps
Note
The
funcon should be supported by the access control device and the card reader.
1. En
ter the Access Control module.
2. On the navigaon bar on the
le, enter Advanced Funcon → More Parameters .
Access Control Terminal User Manual
83