User's Manual

When you work for a certain period aer end-work me on workday, you will reach dierent
overme level: overme level 1, overme level 2 and overme level 3. You can set dierent
work hour rate for three overme levels, respecvely.
Work Hour Rate
Work Hour Rate is used to calculate work hours by mulplying it by overme. When you
work for a certain period aer end-work me on workday, you will reach dierent overme
level. You can set dierent work hour rates (1-10, can be a decimal) for three overme levels.
For example, your valid overme is one hour (in overme level 1), and the work hour rate of
overme level 1 is set as 2, then the work hours in the period will be calculated as 2 hours.
Overme Rule for Weekend
You can enable overme rule for weekend and set calculaon mode.
3. Click Save.
Congure Aendance Check Point
You can set the card reader(s) of the access point as the aendance check point, so that the
authencaon on the card readers will be recorded for aendance .
Before You Start
You should add access control device before conguring aendance check point. For details, refer
t
o Add Device .
Steps
Note
By default, all card readers of the added access control devices are set as aendance checkpoint.
1. En
ter the Time & Aendance module.
2. Click Aendance
Sengs → Aendance Check Point to enter the Aendance Check Point
Sengs page.
3. Oponal: Set Set All Card Readers as Check Points switch to o.
Only the card readers in the list will be set as the aendance check points.
4. Check the desired card reader(s) in the device list as aendance check point(s).
5. Se
t check point funcon as Start/End-Work, Start-Work or End-Work.
6. Click Set as Check Point.
The congured aendance check point displays on the right list.
Congure Holiday
You can add the holiday during which the check-in or check-out will not be recorded.
Face Recognion Terminal User Manual
124