User's Manual

Note
If you change the external device, and aer you save the device parameters, the device will
r
eboot automacally.
6.3.4 Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
1. T
ap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap Wiegand to enter the Wiegand tab.
Figure 6-8 Wiegand Sengs
3. Enable the Wieg
and funcon.
4. Select a transmission direcon.
• Output: A face recognion terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 26 or Wiegand 34.
• Input: A face recognion terminal can connect a Wiegand card reader.
5. T
ap
to save the network parameters.
Note
If you change the external device, and aer you save the device parameters, the device will
r
eboot automacally.
Face Recognion Terminal User Manual
37