User's Manual

Table Of Contents

Table 6-1 Temperature Measurement Parameters Descripons

Parameter Descripon

Enable Temperature Detecon When enabling the funcon, the device will authencate the

permissions and at the same me take the temperature. When

disabling the device, the device will authencate the

permissions only.

Over-Temperature

Thr

eshold(Max./Min.)

Edit the threshold according to actual situaon. If the detected

temperature is higher or lower than the congured parameters,

an alarm will be triggered. By default, the value is 37.3°.

Temperature Compensaon If the measured temperature is higher/lower than the actual

object's temperature, you can set the compensaon

temperature here. Available range: -99 °C to 99 °C

Door Not Open If Temp. is

Abnormal

When enabling the funcon, the door will not open when the

detected temperature is higher or lower than the congured

temperature threshold. By default, the funcon is enabled.

Temperature Measurement

Only

When enabling the funcon, the device will not authencate the

permissions, but only take the temperature. When disabling the

funcon, the device will authencate the permissions and at the

same me take the temperature.

Unit Select a temperature unit according to your preference.

Measurement Area

Calibraon/Measure Area

Sengs

Congure the temperature measurement area and the

correcon parameters.

6.6

Identy Authencaon

Aer network conguraon, system parameters conguraon and user conguraon, you can go

back to the inial page for identy authencaon. The system will authencate person according

to the congured authencaon mode.

ou can authencate identy via 1:1 matching or 1:N matching.

1:N Matching

Compare the captured face picture with all face pictures stored in the device.

1: 1 Matching

Compare the captured face picture with the face pictures linked person informaon in the

device.

Face Recognion Terminal User Manual